Skip to content

Free estimate with a start date you can budget around: (940) 289-8182

Shady Shores · Corinth · Highland Village · Lake Dallas

(940) 289-8182
Two workers in caps and gloves carry an old wood cabinet down a concrete driveway toward a dumpster beside a brick ranch house with a ladder on the roof

ServicesKitchen Remodeling

Kitchen Remodeling in Shady Shores, TX

A kitchen remodel goes smoothest when the hidden parts are planned first: drain slope, circuit capacity, range hood ducting and the permit. We scope those before anything comes out, so your budget reflects the real job and you can schedule it on your timeline.

What a Planned Kitchen Remodel Looks Like

Most kitchen remodels run over budget for the same reason: something behind the wall was not counted. A sink moved to an island needs a new drain with proper slope and venting. A gas range swapped for an induction cooktop needs a dedicated 240-volt circuit the panel may not have room for. A stronger range hood needs ducting to the outside, not into the attic. We look for these items at the estimate visit, before you commit.

The right time to call is before the kitchen forces the decision. A slow leak under the sink, a breaker that trips when the microwave and kettle run together, or a layout that no longer fits how your family cooks are all reasons to start planning now, while you still choose the timing and the scope.

On many homes around Shady Shores, slab foundations sit on clay soil that shifts with wet and dry seasons. That matters when a drain line has to be cut into or rerouted through the slab, so we account for it in the plan rather than discovering it mid-job.

What the Work Includes

Layout and work-zone planning
We measure the room and map the sink, cooktop and refrigerator positions against clearances and traffic flow. Moving any of the three changes plumbing, gas or electrical routing, so the layout is settled first.
Plumbing rough-in
Supply lines, shutoff valves and drain lines are run or relocated to match the new layout. Drains are set with correct slope and venting so they clear properly and do not gurgle or hold odors.
Electrical and lighting
We check panel capacity, then plan dedicated appliance circuits, GFCI protection near water and task lighting where you actually work. Undersized circuits are a common reason older kitchens trip breakers.
Ventilation
Range hoods are sized to the cooktop and ducted to the exterior through a properly sealed wall or roof penetration. Venting into the attic traps grease and moisture, so we do not do it.
Permits and inspections
Plumbing, gas and electrical changes usually need a permit and inspection before walls close. We pull the permit and schedule inspections as part of the job.

Signs It Is Time to Plan a Kitchen Remodel

  • Recurring leaks under the sink

    Corroded supply lines, a weeping trap or soft subfloor below the sink cabinet point to plumbing near the end of its life. Planning a remodel lets you replace it on your schedule instead of after a failure.

  • Breakers that trip often

    If running two appliances at once kills the power, the kitchen is on too few circuits. Adding load to an overloaded circuit is a fire risk, not just an annoyance.

  • Grease and moisture that will not clear

    Sticky surfaces, lingering cooking smells or condensation on windows usually mean the hood is undersized or recirculating instead of venting outside.

  • A layout that fights you

    A sink far from the cooktop or a refrigerator door that blocks the walkway costs time every day. These are layout problems, and they are solved in planning.

How the Project Runs

  1. 1

    Free estimate visit

    We walk the kitchen with you, open the sink base, check the panel and note where the hood can vent. You get a written, line-item estimate that separates required work from optional upgrades.

  2. 2

    Plan and permit

    Once the layout and scope are fixed, we pull the permit and set a start date that works for you. Knowing the scope early gives you time to set aside the budget.

  3. 3

    Demolition and rough-in

    We protect floors and adjoining rooms, shut off water and power to the work area, and remove what is coming out. Plumbing and electrical are run to the new layout, then inspected before anything is covered.

  4. 4

    Finish and walkthrough

    Fixtures, lighting and the hood are connected and tested. We clean up daily and walk the finished kitchen with you, checking every valve, circuit and drain.

Worker pushing a hand truck of tall cardboard boxes up a driveway toward the open garage of a brick home, with a dumpster, ladder and blue tarp nearby

What Moves the Cost of a Kitchen Remodel

The biggest cost driver is how much of the plumbing, gas and electrical moves. Keeping the sink and cooktop where they are usually costs far less than relocating them. Your estimate breaks out each item on its own line, so you can match the scope to your budget and set aside later phases for a time that suits you.

Relocating the sink or gas line
Moving a drain may mean cutting into the slab, which adds labor and an inspection. Moving a gas line means new pipe runs, fittings and a pressure test before the line goes back into service.
Panel capacity
If the panel has no open spaces or the service is too small for new appliance circuits, an upgrade enters the budget.
Ventilation route
A hood on an exterior wall vents with a short duct run. An island hood or interior wall may need ducting through the ceiling and roof.
What we find behind the walls
Water-damaged framing, outdated wiring or failing pipes found during demolition get photographed and priced before we proceed.

Kitchen Remodel Questions We Hear

Something not covered here? (940) 289-8182

How far ahead should I start planning my kitchen?

Give yourself a few months before the date you want work to start. That covers settling the layout, getting the permit and saving without strain. Reaching out before a leak or a wiring fault makes the call for you keeps the schedule yours.

Will the kitchen be usable during the remodel?

For the most part, no, because the room's water and power are off during rough-in. A lot of households put a microwave and coffee maker in another room as a stand-in kitchen. We walk you through the timeline first so you can plan for it.

Is a permit required for a kitchen remodel?

Changes to plumbing, gas or wiring typically need one, and inspections happen before the walls are closed. Pulling the permit and booking those inspections are part of our job.

Does a warranty cover the kitchen work?

Eligible projects carry our workmanship warranty, and the coverage depends on the service. When we prepare your estimate, we spell out what applies to your kitchen.

Do you take kitchen jobs beyond Shady Shores?

Yes. Corinth, Lake Dallas, Hickory Creek and Highland Village are all close by and on our schedule. The Service Areas page lists every other town we cover.

Start Planning Your Kitchen

A phone call gets the estimate visit on the calendar. We will look at the plumbing, wiring and venting and give you a written scope you can budget around.